jbretthorton
Well-known member
My 2010 looking GenIII ish... lol
Quick little "Carbon" Vinyl wrap
- Thread starter jbretthorton
- Start date
Help Support Yamaha FJR Motorcycle Forum:
jbretthorton
Well-known member
Can't decide....
Niehart
Pie Smuggler
Or the cover on the lower back of the gas tank.
jbretthorton
Well-known member
hummm.... yes, the lower tank cover....
Warpdrv
Well-known member
Sexy, nice work...
You should post link to product for those that might also like to be wannabes...
You should post link to product for those that might also like to be wannabes...
jbretthorton
Well-known member
I use Scotch 3M Di-Noc Carbon Vinyl
https://www.ebay.com/itm/like/270700632511?lpid=82
But I buy it local
@ $30 / linear ft (5 ' wide roll)
https://www.ebay.com/itm/like/270700632511?lpid=82
But I buy it local
@ $30 / linear ft (5 ' wide roll)
Last edited by a moderator:
escapefjrtist
Searching for Dry Roads
How much talent does it take to install...and look good?
--G
--G
jbretthorton
Well-known member
I've done several wraps. Its not hard, but does require a certain technique for sure.
Combination of picking the correct sequence, heat, stretching etc...
Combination of picking the correct sequence, heat, stretching etc...
jbretthorton
Well-known member
These pieces where pretty easy, clean with alcohol, start with top section first, trim just to overlap edge. Then a separate piece for the side. Just line up the "grain"
escapefjrtist
Searching for Dry Roads
Fairlaner
The Bartender Whisperer
it's not that hard George.
and then I had a go at the Z.....
and then I had a go at the Z.....
escapefjrtist
Searching for Dry Roads
Very nice Richard!
--G
--G
LagerHead
Well-known member
Damn. Something else I "gotta" have.
Don't forget to cover that panel behind the front wheel below the radiator. While at it get the carbon fibre fender extender.
fjrrrr
Well-known member
There goes my entire weekend !
Similar threads
