Length of Push Pull Fairing Rivets

Beary · Oct 14, 2014

Hi all, my 2012 fairing was mssing a couple of the push/pull rivets. I looked did search and found they are a 6mm diameter, but found nothing on length. I ordered a set from amazon, which turned out much shorter than stock. Does anyone know the stock length, and a good source to get them in bulk?

Thanks ahead for the help.

Beary

DennisJ · Oct 14, 2014

One source: https://www.autoconsumables.com/push-fit-rivets-12-c.asp I think Grainger has been mentioned as a source. Same rivets used by several import auto makers also.

RichDoyle · Oct 14, 2014

Uh, take one off and measure it?

RossKean · Oct 14, 2014

Not all the same length, unfortunately. At least the ones in the wheel well securing the side panels.

DennisJ · Oct 15, 2014

Two dfferent lengths on the '09. Only a few of the short ones though.

HotRodZilla · Oct 15, 2014

I think the long ones will work in place of the short ones. I bought extras a long time ago, but only got the one size.

DennisJ · Oct 15, 2014

Was just over on the Eastern Beaver site and Jim has a selection of clips there along with some dimension drawings. https://www.easternbeaver.com/Main/Elec__Products/Tabs/tabs.html

The long ones will go in where the short ones are used but there are places where the end of the rivet is up against the frame and the rivet is not sitting flush in the opening and doesn't look very secure.

boyitgobob · Oct 15, 2014

Try Bolt

https://www.boltmotorcyclehardware.com/products/sport-bike/sport-bike-rivets.html

Length of Push Pull Fairing Rivets

Help Support Yamaha FJR Motorcycle Forum:

Beary

Active member

DennisJ

Well-known member

RichDoyle

Well-known member

RossKean

Well-known member

DennisJ

Well-known member

HotRodZilla

GOD BLESS AMERICA

DennisJ

Well-known member

boyitgobob

Well-known member

Similar threads

Latest posts

Length of Push Pull Fairing Rivets

Help Support Yamaha FJR Motorcycle Forum:

Active member

Well-known member

Well-known member

Well-known member

Well-known member

GOD BLESS AMERICA

Well-known member

Well-known member

Similar threads

Join the conversation!

Join today and get all the highlights of this community direct to your inbox. It's FREE!