Need GEN III under tank picture of heat shield

Skip Irwin · Apr 17, 2015

I got a feeling that I should take a picture before removing the heat shield but did not... and now I need one. Especially the right side where the throttle cables are located. I recall when removing the heat shield that the throttle cables went through the hole, but now, trying to install the heat shield, I can't see how that was true.

Thanks in advance.....

Skip

Skip Irwin · Apr 17, 2015

Nevermind... coming in to make this request, getting a snack, then sitting down at the bike refreshed made it all clear... the throttle cables are over the heat shield... not under.

mcatrophy · Apr 17, 2015

A bit late, but here you are anyway:
Click on image for larger view

(Edited to use enhanced second picture, shows run of cables better.)

Skip Irwin · Apr 17, 2015

mcatrophy said:
A bit late, but here you are anyway:Click on image for larger view

Thank you. It was so obvious when I came back from a break.

Appreciate your help.

Skip

Constant Mesh · Apr 18, 2015

It appears they've added a separate atmospheric pressure sensor. In one of mcatrophy's photos in the sequence after those shown above you can see two pressure sensors atop the fuel rail.

The Gen I's had two pressure sensors. The Gen II's had one sensor. Now they've gone back to two sensors in Gen III.

Need GEN III under tank picture of heat shield

Help Support Yamaha FJR Motorcycle Forum:

Skip Irwin

Member

Skip Irwin

Member

mcatrophy

Privileged to ride a 2018 FJR1300AS

Skip Irwin

Member

Constant Mesh

Well-known member

Similar threads

Latest posts

Need GEN III under tank picture of heat shield

Help Support Yamaha FJR Motorcycle Forum:

Skip Irwin

Member

Skip Irwin

Member

mcatrophy

Privileged to ride a 2018 FJR1300AS

Skip Irwin

Member

Constant Mesh

Well-known member

Similar threads

Latest posts

Join the conversation!

Join today and get all the highlights of this community direct to your inbox. It's FREE!