MCL Riser Plate on a Gen 3

Advertise with us!
Yamaha FJR Motorcycle Forum

Help Support Yamaha FJR Motorcycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
P

Pgordontrcc

New member
Joined
Jun 20, 2015
Messages
4
Reaction score
0
Location
Dalton, Georgia
Just installed the MCL Riser plate on my 2013 FJR. Everything went smoothly. The drill guide that MCL lets you borrow is a must in my opinion. A little WD-40 and literally 5 minutes to drill both tamper proof bolt heads. Did run the throttle cables under the handle bar for slack reasons. Cant wait to put some miles on them to check the effect on back pain.

 
Last edited by a moderator:
I don't recall re-routing cables.

My bike with the MCL riser plate is a Gen II. Not sure if there are differences with install for the Gen III? I followed the instructions provided with the riser plate.

I suggest being sure that any cable re-routing doesn't interfere with throttle operation (try throttle with bars in all positions from right to left lock).

 
Last edited by a moderator:

Similar threads

F
Parts For Sale Gen III stuff for free if you’re in the IBR
Replies
16
Views
1K
fastpappy
fastpappy
Streethawk
Motorcycle Larry Handlebar Riser Plate for Gen 2 $175 shipped
Replies
8
Views
418
FTL900
FTL900
V
SOLD! MV handlebar riser plate
Replies
3
Views
208
VMaxChuck
V
D
Riser Plate for Gen I
Replies
2
Views
506
escapefjrtist
escapefjrtist
ogopogo
Bar-backs, gen III, DIY
Replies
5
Views
642
ogopogo
ogopogo

Latest posts

Top