Recent content by Dave Mc

Thanks... I have already checked with Home Depot; and had no sucess. I have a "Hobby" store close by, I will try them tonight.

Where can I find a replacement screw for the locking mechanisim of my saddle bag. There are two screws that are very small that hold the lock in place. I am sure someone else has had to replace one of them. I should have said that I have already checked with the dealer.

Yessir rom, what state u located in?

Thanks everyone. There is a lot of information here, including the NE website. I will have to map everything out to see what is possible. I will post a draft of my route in a few days, so I can get some comments. Thanks

A couple freinds and I will be making a trip at the end of May through all of these areas. I have never been through these areas on a bike, is there anything we must see or experience. I know it's a big area. As it stands now, we are leaving from North NJ with our first lodging in...

https://www.lt1engines.com/tech/how-to-seafoam-your-car-clean-carbon-buildup/. Has anybody gone this far to remove carbon buildup? Or have you just added it to the fuel tank?

To those saying it's the battery...I've replaced mine and I still have the same problems. However, tonight I will go back and remove my trickle charge harness and optional fuse expansion panel from the battery terminals and clean positive and negative connections really good, but I don't think...

Denver, Did you ever find the cause? This sounds very much like the issues I am having with my 07? To date, I have changed the battery and added Chevron fuel injector cleaner to the gas tank, but I not finished with the first tank of gas. Started the bike last night and it still has the same...

the bike was cold in the sense that it hadn't been started in a week, but the outside temp was about 80. After starting the bike, I rode it for about two hours - and the problem never happened again.

I have an 07 with 15K miles The bike starts but will eventually stall in 15 seconds. If I give it a little gas it will stall immediately. If if give it a lot of gas, it will rev then stall. Between restarts - I usaully have to turn the bike fully off. I am the third owner of the bike, but...

I got the answer... On high, the electric flows from A to grips. There is a internal pivot inside the switch. Edit: I learned three things: the sitch, how to draw a picture with paint, and how to post a picture:

I just got my hot grips, and the instructions are a little lacking. Can anyone explain how the electric flows. I am thinking when you flip the switch to high electric flows from A to grips, and when you flip the switch to low... electric flows from B to grips. This makes sense to me, but I just...

https://i1235.photobucket.com/albums/ff425/dmcg00/th_grips.png?t=1292983113 I just got my hot grips, and the instructions are a little lacking. Can anyone explain how the electric flows. I am thinking when you flip the switch to high electric flows from A to grips, and when you flip the...

At that temperature (teens).... the other way to go is by car.

Please take a look at the switching lead.. My question is what should I connect this to? https://www.easternbeaver.com/Main/Products/Fuseboxes/PC-8/body_pc-8.html#30akit