Search results

PM sent. You have $$$.

PM Sent on the touring windshield.

Size Large for me please. And thank you for doing this.

I have the Canyon Cages. Also a short inseam 27". I've dropped it once since I installed them. It went all the way down as I was heading downhill and the driveway sloped to the left also. The bike got minor scratches on the left mirror and the faring edge below the mirror. No scrapes to the...

SOLD.

That CBF 1000 is a good looking bike. Too bad they are not for sale in the US. I'd likely have owned one if they had been.

Thanks, sent my seat off today for a day-long build.

ON HOLD, pending payment.

Just got mine installed. Perfect fit. And yes, it does look much too nice to be sitting on the ground.

Already got my order in. This will be my 4th Day-Long seat. The 1st was back when Meyer built them, the others were from Russell. Obviously, I like these seats.

This is a Gen 1 factory dirvers seat section only. It is in very good condition, no rips or tears in the vinyl, pan is good. This would be ideal for a Russell build (which is 15% off if you place your order by end of business Friday, Oct 11th). Asking $38.00 plus actual shipping. Located in...

If you decide to try a Russell, ordering it by end of business Friday, Oct 11 will get you a 15% discount. On a dual seat setup, that is significant.

Just saw this thread. I have installed the Helibars bridge. The brake hose extention is not as nice to look at as a standard hose, but works just fine. You do need to cut the factory hose/cable guides to remove the guide assembly, which also has the bar attachment, from the triple clamp or you...

Ok, guess I'm the 2nd US guinea pig. Ordered 1 from Amazon also.

Yes, I installed the Helibars "bridge" on my FJR a few weeks ago. The install was not too difficult. You do need to remove the top triple clamp, but only to allow you to remove the bar mounting hardware from it. It then goes right back on. The ignition switch remains in place on the clamp...

Installed Canyon Cages and Saddlebag Guards last weekend. I had a friend lend a hand to hold the cages while I aligned and tightened bolts. Took less then 2 hours. As per usual, get all the bolts started before tightening down hard.

You could talk with some name brand moving companies. They would load your bike onto their trailer and haul it to you. Since one bike will come no where close to filling a moving van, you would have to wait for a load headed in your direction that had some room. Still, years ago I shipped my...

Throttlemeister is taken.

Let me know if you would be interested in selling the seat separately. I have a 2009 with stock seats that could be swapped over. I'm around 50 miles from Denver. Ken

I had a Russell with a backrest on my NT700V, which has a similar riding position to the FJR. I found that a lot of the time I did not use the backrest. I mainly used it when my feet were on the highway pegs and I was leaned back a bit more then when my feet were in the normal riding position...