Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
ABS test coupler
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="wil780" data-source="post: 1396651" data-attributes="member: 24008"><p>I couldn't get this to work on my '06. The connector is exactly the same, and I had no trouble identifying the pins that are connected to each other in the photo. When I turned on the ignition (with the kill switch set to off) the ABS light would not stop flashing. I checked the battery voltage as the Service Manual recommends, and it was fine. Connecting a charger pushed the voltage even higher, but the ABS light kept flashing. I even tried doing the test but nothing happened, as the Manual predicted when the light is flashing. The light went off as soon as I removed the alligator clamp connecting the pins.</p><p></p><p>The ABS was working a few hundred km ago (I test it occasionally). I could go out and test it again to make sure it's working and to cycle the fluid, then do another brake fluid flush. But I wasn't planning on insuring the bike for a few weeks, and it would be nice to finish the job before cleaning up the mess.</p><p></p><p>Suggestions, other than a defective ABS unit?</p></blockquote><p></p>
[QUOTE="wil780, post: 1396651, member: 24008"] I couldn't get this to work on my '06. The connector is exactly the same, and I had no trouble identifying the pins that are connected to each other in the photo. When I turned on the ignition (with the kill switch set to off) the ABS light would not stop flashing. I checked the battery voltage as the Service Manual recommends, and it was fine. Connecting a charger pushed the voltage even higher, but the ABS light kept flashing. I even tried doing the test but nothing happened, as the Manual predicted when the light is flashing. The light went off as soon as I removed the alligator clamp connecting the pins. The ABS was working a few hundred km ago (I test it occasionally). I could go out and test it again to make sure it's working and to cycle the fluid, then do another brake fluid flush. But I wasn't planning on insuring the bike for a few weeks, and it would be nice to finish the job before cleaning up the mess. Suggestions, other than a defective ABS unit? [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
ABS test coupler
Top