Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Differences between Gen 2 and Gen 1 & 2.5 Clutch Assemblies
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="richsp51" data-source="post: 1142022" data-attributes="member: 85522"><p>Ross, I have a 2007 and as you see, back in December I was active in this thread because I too was seeking an easier clutch pull. I was concerned about the same issues as you.</p><p></p><p>I have since replaced my clutch slave cylinder with a 2005 (GEN I) slave cylinder and at the same time installed genuine Pazzo levers and I am very happy with the results. I have my clutch lever set to position 4 and the engagement is just fine for me, albeit a bit close to the grip...but not so much more then before. I have not experienced any clutch slipping and clutch pull is noticeably less, however, I cannot give you a quantitative answer as to how much less.</p><p></p><p>Since you already have the Pazzos, it doesn't take much effort or cost to get a replacement GEN I slave cylinder to try out for yourself. I got mine on eBay for about $25 shipped. It's a simple swap out.</p><p></p><p>Best regards and good luck.</p></blockquote><p></p>
[QUOTE="richsp51, post: 1142022, member: 85522"] Ross, I have a 2007 and as you see, back in December I was active in this thread because I too was seeking an easier clutch pull. I was concerned about the same issues as you. I have since replaced my clutch slave cylinder with a 2005 (GEN I) slave cylinder and at the same time installed genuine Pazzo levers and I am very happy with the results. I have my clutch lever set to position 4 and the engagement is just fine for me, albeit a bit close to the grip...but not so much more then before. I have not experienced any clutch slipping and clutch pull is noticeably less, however, I cannot give you a quantitative answer as to how much less. Since you already have the Pazzos, it doesn't take much effort or cost to get a replacement GEN I slave cylinder to try out for yourself. I got mine on eBay for about $25 shipped. It's a simple swap out. Best regards and good luck. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Differences between Gen 2 and Gen 1 & 2.5 Clutch Assemblies
Top