Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Fault Code 12
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MotoMike" data-source="post: 1463601" data-attributes="member: 92743"><p>Symptoms are as follows: When the engine is started and run from a cold start, there is already one bar showing on the temperature guage with ignition in the "on" position before startup. The guage then rapidly runs up to 9 bars within 2 minutes of startup. After the 2 minutes of running, I turned off the engine and and carefully put my hand on the radiator and on the coolant pipes on top of the engine. They felt lukewarm at most. I then carefully removed the radiator cap. There was no pressure release and no steam. The radiator was full. I carefully plunged my finger into the coolant. It was lukewarm at most. Also, before I did any of that, I did pull off, inspect and re-connect the connector.</p></blockquote><p></p>
[QUOTE="MotoMike, post: 1463601, member: 92743"] Symptoms are as follows: When the engine is started and run from a cold start, there is already one bar showing on the temperature guage with ignition in the "on" position before startup. The guage then rapidly runs up to 9 bars within 2 minutes of startup. After the 2 minutes of running, I turned off the engine and and carefully put my hand on the radiator and on the coolant pipes on top of the engine. They felt lukewarm at most. I then carefully removed the radiator cap. There was no pressure release and no steam. The radiator was full. I carefully plunged my finger into the coolant. It was lukewarm at most. Also, before I did any of that, I did pull off, inspect and re-connect the connector. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Fault Code 12
Top