Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Gen I Rostra Install Advice Needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="neilj14" data-source="post: 1303130" data-attributes="member: 88605"><p>I have installed my Rostra kit and it is giving me some issues with searching. Pulls a steady speed going up a hil (presumably because the cable pull is fully engaged) but on level ground it will move up and down approximately 5mph or slightly less. The dip switch settings I am using are as follows;</p><p></p><p>1 - Off</p><p></p><p>2 - Off extra low</p><p></p><p>3 - On</p><p></p><p>4 - On</p><p></p><p>5 - On</p><p></p><p>6 - On</p><p></p><p>7 - Off</p><p></p><p>8 - Off</p><p></p><p>9 - off</p><p></p><p>10 - On</p><p></p><p>11 - On</p><p></p><p>12 - Off</p><p></p><p>Is there a particular one of these settings that should minimize this issue? I got these settings from Kens install, a Gen 2 bike. When I used the Gen 1 settings listed in this forum I got no response from my unit. I do note on setting 12 that I am using a wired switch, not a remote unit. Not sure if this change will make a difference. Maybe I will give this a try.</p><p></p><p>Any suggestions would be greatly appreciated.</p><p></p><p>Thanks,</p><p></p><p>Neil</p></blockquote><p></p>
[QUOTE="neilj14, post: 1303130, member: 88605"] I have installed my Rostra kit and it is giving me some issues with searching. Pulls a steady speed going up a hil (presumably because the cable pull is fully engaged) but on level ground it will move up and down approximately 5mph or slightly less. The dip switch settings I am using are as follows; 1 - Off 2 - Off extra low 3 - On 4 - On 5 - On 6 - On 7 - Off 8 - Off 9 - off 10 - On 11 - On 12 - Off Is there a particular one of these settings that should minimize this issue? I got these settings from Kens install, a Gen 2 bike. When I used the Gen 1 settings listed in this forum I got no response from my unit. I do note on setting 12 that I am using a wired switch, not a remote unit. Not sure if this change will make a difference. Maybe I will give this a try. Any suggestions would be greatly appreciated. Thanks, Neil [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Gen I Rostra Install Advice Needed
Top