Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
FJR Parts & Accessories Discussions
Grip ID help needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="radiummadman" data-source="post: 1189328" data-attributes="member: 28819"><p>easy way to install grip puppies/other similar. Take some good electrical tape, ie: 3m 33+ or 1700 temflex or = in Plymouth or other.</p><p></p><p>wrap about 1 1/2 turns around the grip on the bike & leave about 6" pigtail on each end. Spray soapy water on both the tape/grips that are on</p><p></p><p>the bike & on inside of the foam grips. They will slide right on, maybe a little twist is needed BUT twist with the direction of the tape</p><p></p><p>you wrapped on the existing grips. Then gently pull the tape pigtail until all of the tape is gone, if you break it pull from the other end.</p><p></p><p>about as easy as it gets and you do not have to pull on the grips with the possibility of ripping them. OK now comes all of the what a smart</p><p></p><p>mother fucker I am, however I must admit this idea was a result of looking at 3M cold shrink. bla bla & saco un flaco taco.</p></blockquote><p></p>
[QUOTE="radiummadman, post: 1189328, member: 28819"] easy way to install grip puppies/other similar. Take some good electrical tape, ie: 3m 33+ or 1700 temflex or = in Plymouth or other. wrap about 1 1/2 turns around the grip on the bike & leave about 6" pigtail on each end. Spray soapy water on both the tape/grips that are on the bike & on inside of the foam grips. They will slide right on, maybe a little twist is needed BUT twist with the direction of the tape you wrapped on the existing grips. Then gently pull the tape pigtail until all of the tape is gone, if you break it pull from the other end. about as easy as it gets and you do not have to pull on the grips with the possibility of ripping them. OK now comes all of the what a smart mother fucker I am, however I must admit this idea was a result of looking at 3M cold shrink. bla bla & saco un flaco taco. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
FJR Parts & Accessories Discussions
Grip ID help needed
Top