Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
KrZy8 Gen2 - Charging Circuit
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="dcarver" data-source="post: 983895" data-attributes="member: 956"><p>Excellent point Fred, 'crisply' made (pun intended!)</p><p></p><p>On that same note, I *finally* located the <strong>power</strong> wires for the ABS brakes. They are buried toward the inner side, center, of the bike's width, above the RR plate. The connector looks like a beotch to get at - it's connected to the bracket housing the pump, requiring disassembly at arms reach while laying on the floor. I so want a lift. This connector is the last of the power circuit I've not had apart. I doubt it's leaking any current, but it would be 'curious' to disconnect it and see what happens to the VDC drop from batt + to RR output +. Thoughts? Worthwhile to chase it down since I'm this deep into it or just not worth the ROI?</p><p></p><p>One other connector I've not been into for inspection is the ECU - same question, leave alone or should it too be looked at, just for grins and giggles?</p></blockquote><p></p>
[QUOTE="dcarver, post: 983895, member: 956"] Excellent point Fred, 'crisply' made (pun intended!) On that same note, I *finally* located the [B]power[/B] wires for the ABS brakes. They are buried toward the inner side, center, of the bike's width, above the RR plate. The connector looks like a beotch to get at - it's connected to the bracket housing the pump, requiring disassembly at arms reach while laying on the floor. I so want a lift. This connector is the last of the power circuit I've not had apart. I doubt it's leaking any current, but it would be 'curious' to disconnect it and see what happens to the VDC drop from batt + to RR output +. Thoughts? Worthwhile to chase it down since I'm this deep into it or just not worth the ROI? One other connector I've not been into for inspection is the ECU - same question, leave alone or should it too be looked at, just for grins and giggles? [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
KrZy8 Gen2 - Charging Circuit
Top