Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
rebound damping issue - uneven clicks
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="becoyote" data-source="post: 1273073" data-attributes="member: 3940"><p>I didn't pull out the adjusting rods and measure them but I did throw a ruler next to each to see they were sticking above the damping rods the same distance.</p><p></p><p>The damping rods are both sticking out of the tubes the same distance and yes if I push down on the adjusting rods they spring back. I took it for a ride yesterday after I put it back together and everything felt normal other than it was a little harsh and I wanted to back of the compression damping a bit.</p><p></p><p>I did have the forks completely apart and did new bushings too so I had the cartridges out. If they weren't sitting correctly I would see a difference at the top though, right?</p></blockquote><p></p>
[QUOTE="becoyote, post: 1273073, member: 3940"] I didn't pull out the adjusting rods and measure them but I did throw a ruler next to each to see they were sticking above the damping rods the same distance. The damping rods are both sticking out of the tubes the same distance and yes if I push down on the adjusting rods they spring back. I took it for a ride yesterday after I put it back together and everything felt normal other than it was a little harsh and I wanted to back of the compression damping a bit. I did have the forks completely apart and did new bushings too so I had the cartridges out. If they weren't sitting correctly I would see a difference at the top though, right? [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
rebound damping issue - uneven clicks
Top