Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Replacing headlamp bulbs on Gen III?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="NormKern" data-source="post: 1130186" data-attributes="member: 86443"><p>Found a tutorial with pics of the process on a gen II (2009 I think) on an Aussie site. My owners manual says nothing other than take it to the dealer. Haven't bought a shop manual yet, but it won't necessarily offer any enlightenment.</p><p></p><p>Funny story- I needed to remove the carbs on my '86 Kaw Concours once and saw no way to do it, so I ordered the shop manual for about $60. When it arrived I looked in the table of contents and sure enough there was a section titled 'carburetor removal', so I eagerly went to the page. The first sentence read, "After the carburetors are removed..." Since then, I have always looked around for other info before diving into a shop manual.</p><p></p><p>Owned a m/c shop back in the late 70s-early 80s and did lots of service work back then, so am sure I can figure it out- just looking to see if there are any non-obvious shortcuts. The dash panels will have to come out on the gen III to allow my fat fingers to get in there.</p></blockquote><p></p>
[QUOTE="NormKern, post: 1130186, member: 86443"] Found a tutorial with pics of the process on a gen II (2009 I think) on an Aussie site. My owners manual says nothing other than take it to the dealer. Haven't bought a shop manual yet, but it won't necessarily offer any enlightenment. Funny story- I needed to remove the carbs on my '86 Kaw Concours once and saw no way to do it, so I ordered the shop manual for about $60. When it arrived I looked in the table of contents and sure enough there was a section titled 'carburetor removal', so I eagerly went to the page. The first sentence read, "After the carburetors are removed..." Since then, I have always looked around for other info before diving into a shop manual. Owned a m/c shop back in the late 70s-early 80s and did lots of service work back then, so am sure I can figure it out- just looking to see if there are any non-obvious shortcuts. The dash panels will have to come out on the gen III to allow my fat fingers to get in there. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Replacing headlamp bulbs on Gen III?
Top