Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Where to tap into a "switchable power" source?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Bounce" data-source="post: 1405452" data-attributes="member: 257"><p>Trigger leg to a relay can be powered via the windshield auto-retract jumper on many models.</p><p></p><p><a href="https://www.fjr-tips.org/mods/shield/shield.html" target="_blank">https://www.fjr-tips.org/mods/shield/shield.html</a></p><p></p><p>If you want to run to something in the back so you don't have to route over/around the engine, then you use a pin puller, get a keyed-on source from a multi-gang connector, solder together a Y and re-insert the pin. This "tapes the low voltage into your wiring harness without compromising your harness' insulation. I did that in this example.</p><p></p><p><a href="https://www.fjr-tips.org/mods/hyper/hyper.html" target="_blank">https://www.fjr-tips.org/mods/hyper/hyper.html</a></p></blockquote><p></p>
[QUOTE="Bounce, post: 1405452, member: 257"] Trigger leg to a relay can be powered via the windshield auto-retract jumper on many models. [URL="https://www.fjr-tips.org/mods/shield/shield.html"]https://www.fjr-tips.org/mods/shield/shield.html[/URL] If you want to run to something in the back so you don't have to route over/around the engine, then you use a pin puller, get a keyed-on source from a multi-gang connector, solder together a Y and re-insert the pin. This "tapes the low voltage into your wiring harness without compromising your harness' insulation. I did that in this example. [URL="https://www.fjr-tips.org/mods/hyper/hyper.html"]https://www.fjr-tips.org/mods/hyper/hyper.html[/URL] [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Where to tap into a "switchable power" source?
Top