Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Wiring for Gen III Headlight Relay
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="FJReady" data-source="post: 1298825" data-attributes="member: 465"><p>On the 2014ES model there are 3 relays below the speedometer location in the wiring harness. Sitting on the seat, looking at the speedo, the relay you want for Clearwater controller is the right one(in the group of 3). This relay has the two wires described in the Clearwater instructions: the +12V power and high beam trigger wire. Sorry, I didn't take any photos.</p><p></p><p>The relay is partially hidden by a section of the wiring harness. I had to clip a cable tie that was holding it there in order to wiggle the relay loose from its mount so I could tap into the wires. Then installed a new cable tie when wiring was done. This was just for the two wires mentioned above. Ground wire will go over to the battery.</p></blockquote><p></p>
[QUOTE="FJReady, post: 1298825, member: 465"] On the 2014ES model there are 3 relays below the speedometer location in the wiring harness. Sitting on the seat, looking at the speedo, the relay you want for Clearwater controller is the right one(in the group of 3). This relay has the two wires described in the Clearwater instructions: the +12V power and high beam trigger wire. Sorry, I didn't take any photos. The relay is partially hidden by a section of the wiring harness. I had to clip a cable tie that was holding it there in order to wiggle the relay loose from its mount so I could tap into the wires. Then installed a new cable tie when wiring was done. This was just for the two wires mentioned above. Ground wire will go over to the battery. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Wiring for Gen III Headlight Relay
Top