Recent content by McRide

All tools were set and ready to go for a clutch soak, and I thought <let's just have more more look for something obvious>... lol, found it... I never installed the brass clutch lever bushing when changed out to Pazzo's a few years ago. Quick ride today and all is back to normal.

Have them... and will follow your procedure, thanks

The Clutch Plates need some TLC but, as I was having a quick <getting up the nerve> glance at the bike, it was clear that the Canyon Cage is likely in the way. Before I add the extra work of removing the Cage, I thought perhaps someone has removed the Clutch Cover Plate through those tight...

Thanks Matt... I appreciate the tech timeline you've assembled... goes in the folder. Seems like a good day for an oil change.

Looking from under, where the L and R Fairings fronts come together at a point, you should see one or two screws. Those attach the bottoms of the fairings via a concealed molded plastic tab...

12" SAE, and bring it down from the battery, tucked behind the side fairing and it will simply pull out from one of the molded vent openings for easy access.

Regrets... plans have changed. Will be riding to grandkids in Montana the following week and just can't add another 1,300 mile leg. Cancelled room available as of tonight.

Looking to get another SR10... I went to install mine, then realized I left it on the '04 when sold a few years ago, dang. In my defense, it was hardwired under the seat, so there's that, lol.... I know from experience the Escort will pair direct with the Sena 20, but Escort also requires that...

Found OEM Bleeders on Partshark, here in a few days. Had the same thoughts on the SB Check Valve vs Vacuum Air Pressure, likely not going to move the ball bearing. I'll try again soon and post results, thanks every one, Cheers!

So... I was going to change out the Speed Bleeders to factory, but no one has them. Sitting in Japan. I picked some generic 7mm/1.0 but have decided to stay with SB for now. Front wheel is done and I'm on the front right lower, linked to rear. It's cracked open 1/4 to 1/2 turn and on the...

Thanks, yes, the SB are ...meh... They are new to me, seemed like a good shortcut but perhaps too finicky for me. I'll do the front link, then the rear and keep an eye on the REAR resvr. Duh.

Most helpful, thanks.... is the linked front-rear fed from the Handlebar Resvr or the Rear Resvr?

Doing a Front and Rear Brake Bleed.... Done many times but, this time, I let the rear Reservoir go to zero and air got in. Maybe deep, and refilled. I have the rear speed bleeder cracked open and under about 25psi vacuum and I have the rear pedal tied down to full brake. Nothing is moving out. I...

I heard I'm in....

Putting my bet on Battery