Mens Aerostich R-3 size 42R with the back protector. Bought new in December of 22. I have worn it in on approximately 10 rides and decided a one piece wasn't for me. Asking $900.
Thanks to everyone for the information. I am going to spend some time this weekend with a mock up and see where it fit best for my use.
I have gone back and forth between the PC8 and the Fuzeblock. The PC8 seems very nice, but the Fuzeblock wiring looks easier to route in my opinion.
I just a got new to me 2020 FJR ES. I am going to install an auxiliary fuse block like I had on my 08. The question I have is can I mount it under the front seat in the storage space, even though there is an electronic box there. I believe it is for the suspension or look for another location...
I didn't think I would ever sell this bike, but bought a 2020 FJR and don't have room to keep both. It is older, but at 74,836 miles it just barley broken in for an FJR.
It's a 2008 FJR A model with a Penske shock upgrade, upgraded springs in the forks, LAAM custom seat, Garmin 395 LM GPS, Aux...
Thanks again to everyone who chimed in with suggestions.
I found my problem...when I replaced the pushrod from the the clutch master to the brass bushing I put it in backwards. Fortunatley it was any fix and stuck out as soon as I disassembled the clutch lever. On the plus I side it was not...
Well I think I am going to start from square one and look at my clutch master and slave cylinder. If that doesn't show me anything I will inspect the clutch plates. Hopefully it is something simple. Odds are it is probably something I did and not the clutch. Fingers crossed I can figure it out...