Search results

Did you bought and installed a used one abs pump unit?

I had a good luck with that freeze spray on some cases.Heat didn't helped much.Anyway...He could try both heat and if doesn't help,then with the freeze spray..

The heat at that area will worse the things due to the expansion.The metal there will need contraction to remove the pins.A like this freeze spray will do the job i believe...

Firstly clean the area well and have a look around there from where this liquid comes 😉🙂Also it is easy to comfirm what liquid is,coolant or oil...

Hello.Welcome from Greece.

Hello from Greece.Welcome to the forum!

Repairable here with life time warranty https://diag-engine.com/abs-pump-motorcycle/yamaha/2467-fjr-1300.html If you buy a used one from ebay probably will have the same problem right now or in the short future..

Unfortunately the problem is inside the unit"Stucked valves"Caused if you don't change often the fluids every one or two years and if you don't activate often the unit by your self on a slippery road carefully. Repairable here with lifetime warranty:Read the description..: Email them for more...

Abs unit is malfunctioning.. Repairable here with lifetime warranty: https://diag-engine.com/abs-pump-motorcycle/yamaha/2467-fjr-1300.html

I use the Belray assembly lube for many years.Great product!Same as Honda Moly60 or better.Read the description: https://www.ebay.com/itm/256048502415

Also remove the ECU connector and check the pins there for any corrosion.If the problem remains,then perhaps the ignition switch started to fail..Also on what colour wire/pin you found the green oxidation?Only on one or to all the connector pins if you remember?

Lift the tank and remove the T-bar.Under of it there you will find some connectors.Unplug them and check for corrosion on their pins.These connectors can cause a lot of troubles!Also unplug the ECU connector and check the pins if they are in good condition.Please let us know about..

😉🙂

zdravo wlayco 🙂

Hello from Athens Greece.🙂Welcome to the forum!

Here it is available right now:https://www.cmsnl.com/products/fjr1300-rear-carrier_1mc248d000/

Well,I don't like it very much..I would like to see a Gen1 or a Gen2 with the oem top case or without a top case.This is a Givi top case..Also the side cases are the city version and not the touring version..The picture looks like a cartoon picture..Anyway,again,i don't like it very much but it...

Hello from Athens Greece 🙂Welcome to the forum!

Thanks! So,waiting until they make it.. I would like to install this thing on the seat.I believe that it works well on hot days..Especially for my Gen 1 that it blows tons of hot air at summer on that area ... 🙂

5 hours???!!! 😯I need about 2+ days for these jobs!!! 🙂😂