Search results

I finally had a moment to dig deep to find the issue. So, to close this string out, after being led to the ignition switch, thank you for pointing me in that direction, I tested the switch via the two smaller wires connected to the switch at the red and white connector. They tested fine; open...

The sidestand switch checks out at the clutch switch. So, on to the ignition switch.

OK. Did I read somewhere there is a way to jump the switch to verify the contacts? I suppose I can go to the connection for the ignition switch harness and check for continuity.?

I did via Diag 62. Right back to start it up, big fat 19 on the screen. I tried to put it into gear and leave the kickstand down; did not pull in the clutch. Then, it would not crank. But I'm not sure that's at the ECU vs. ECO. Can't figure out why Diag 21 shows OFF and OFF, no matter the...

'05 Gen 1 with a code 19. Will crank, won't start issue. Diagnostic #20 reads "Off" for the kick-stand either up or down while the bike is in gear. I checked the switch for continuity at the connection just under the fuel tank and it shows open and closed depending on the stand position, so I...

I'm working on a stolen/recovered '05 FJR ABS. I replaced the ignition, verifying I had the correct wires in the correct slots. I replaced the maligned starter solenoid. However, when I put power to the unit and turned the ignition (key) to run, the 10amp ignition fuse blew. I checked and...