Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
AE only, intermittent paddle shift failure
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="mcatrophy" data-source="post: 1203975" data-attributes="member: 3187"><p>Sounds very strange if it really is only 1st to 2nd and the foot switcher still works.</p><p></p><p>There's no difference in signals to the MCU regardless of the gear, no difference to the MCU's reaction to either hand or foot signal. If it was an electrical issue (bad switch or connector), it would show up in any gear.</p><p></p><p>The only reason I can think of is the idle speed is high and you are trying to change up before the 1st gear revs have built up enough. This can happen with the cold idle when <em>you</em> know it would be fine, but the MCU isn't so sure.</p><p></p><p>Next time it does it, accelerate so the revs are higher, then try again.</p></blockquote><p></p>
[QUOTE="mcatrophy, post: 1203975, member: 3187"] Sounds very strange if it really is only 1st to 2nd and the foot switcher still works. There's no difference in signals to the MCU regardless of the gear, no difference to the MCU's reaction to either hand or foot signal. If it was an electrical issue (bad switch or connector), it would show up in any gear. The only reason I can think of is the idle speed is high and you are trying to change up before the 1st gear revs have built up enough. This can happen with the cold idle when [I]you[/I] know it would be fine, but the MCU isn't so sure. Next time it does it, accelerate so the revs are higher, then try again. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
AE only, intermittent paddle shift failure
Top