Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Off-Topic Discussion
Off-Topic Discussion
AE shifting and 1st gear engagement problem solved - incorrect engine oil viscosity
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Oakdave" data-source="post: 1403812" data-attributes="member: 29079"><p>It might help knowing that, following the oil change and before riding the next morning, I did start the engine and allowed it to run for several minutes at full operating temperature. I engage in and out first gear several times (while on the center stand). I did that in hopes of getting the clutch plates/pads as much lubricated as possible with the new oil mixture. My routine (of starting the bike and going) was no different than usual--i.e., start the bike, wait about 2 minutes to reach one or two bars on the temp gauge..and go).</p></blockquote><p></p>
[QUOTE="Oakdave, post: 1403812, member: 29079"] It might help knowing that, following the oil change and before riding the next morning, I did start the engine and allowed it to run for several minutes at full operating temperature. I engage in and out first gear several times (while on the center stand). I did that in hopes of getting the clutch plates/pads as much lubricated as possible with the new oil mixture. My routine (of starting the bike and going) was no different than usual--i.e., start the bike, wait about 2 minutes to reach one or two bars on the temp gauge..and go). [/QUOTE]
Insert quotes…
Verification
Post reply
Off-Topic Discussion
Off-Topic Discussion
AE shifting and 1st gear engagement problem solved - incorrect engine oil viscosity
Top