Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Ambient air temp sensor location?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Fred W" data-source="post: 1321183" data-attributes="member: 3828"><p>That was from the 2014 Factory Service Manual, electrical component location diagram. In another section of the manual where they tell you how to test the sensor, it indicates you would remove it from the windshield mechanism.</p><p></p><p>The same type of diagram for a 2nd Gen calls that sensor the Intake Air Temp Sensor, and shows it screwing into the airbox from under the back end of the gas tank, and describes removing it from the airbox for testing..</p><p></p><p>In the wiring diagrams for the 2nd Gen the Intake Air Temp Sensor is wired to the ECU, which makes sense. There is another item called "Thermistor" that goes to the multifunction meter, which must be the ring lug ambient temp sensor. There is no second "Thermistor" on the 3rd Gens, so it must share the same air temp sensor as the ECU.</p></blockquote><p></p>
[QUOTE="Fred W, post: 1321183, member: 3828"] That was from the 2014 Factory Service Manual, electrical component location diagram. In another section of the manual where they tell you how to test the sensor, it indicates you would remove it from the windshield mechanism. The same type of diagram for a 2nd Gen calls that sensor the Intake Air Temp Sensor, and shows it screwing into the airbox from under the back end of the gas tank, and describes removing it from the airbox for testing.. In the wiring diagrams for the 2nd Gen the Intake Air Temp Sensor is wired to the ECU, which makes sense. There is another item called "Thermistor" that goes to the multifunction meter, which must be the ring lug ambient temp sensor. There is no second "Thermistor" on the 3rd Gens, so it must share the same air temp sensor as the ECU. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Ambient air temp sensor location?
Top