Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Audiovox install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="xlauto" data-source="post: 1329209" data-attributes="member: 89846"><p>Okay, I have changed the DIP switch setting as indicated above to 1&4 'on', remaining switches 'off'. For some reason the jumper (little black box) in the actuator wasn't there so I guess that was not the problem. The two pins are exposed which is located right beside the LED light.</p><p></p><p>I have installed the check valves, a three port check valve for the homemade canister and one of the vacuum draws and a two port check valve for the other vacuum draw. I am only working off of two vacuum draws now. I pulled one of the draws off and checked vacuum pressure. At idle I am drawing about 44 kPa of vacuum pressure. When I shut the bike off, the pressure stays constant so I am not losing pressure in the system.</p><p></p><p>I am still not having any luck. It will not engage.</p><p></p><p>I am leaving the purple wire attached to the battery ground for now until I can get the CC engaging.</p></blockquote><p></p>
[QUOTE="xlauto, post: 1329209, member: 89846"] Okay, I have changed the DIP switch setting as indicated above to 1&4 'on', remaining switches 'off'. For some reason the jumper (little black box) in the actuator wasn't there so I guess that was not the problem. The two pins are exposed which is located right beside the LED light. I have installed the check valves, a three port check valve for the homemade canister and one of the vacuum draws and a two port check valve for the other vacuum draw. I am only working off of two vacuum draws now. I pulled one of the draws off and checked vacuum pressure. At idle I am drawing about 44 kPa of vacuum pressure. When I shut the bike off, the pressure stays constant so I am not losing pressure in the system. I am still not having any luck. It will not engage. I am leaving the purple wire attached to the battery ground for now until I can get the CC engaging. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Audiovox install
Top