Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
FJR Parts & Accessories Discussions
Auxiliary lights MondoMoto MM10
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="graler" data-source="post: 1081218" data-attributes="member: 23510"><p>My lights are always on - no intermediate switch. I have them bolted directly to the front fender bolts. I have not noticed a significant amount of vibration but I also have not been paying that much attention to it. These lights for me are more about being seen instead of seeing. They do throw a lot of light down by the front tire. That is because they are mounted low.</p><p></p><p>I put an Eastern Beaver fuse block and the lights and Skene controller are wired to that. The EB has 2 unswitched ports and the remaining lines are switched. These lights are on the switched ports. If you put the fuse block under the passenger seat there is a blue wire back there going to the tail light. That is the wire that is tapped for the EB.</p><p></p><p>I also had to tap two wires up front. A high beam wire and the low beam wire. I can't recall what the colors are off hand.</p></blockquote><p></p>
[QUOTE="graler, post: 1081218, member: 23510"] My lights are always on - no intermediate switch. I have them bolted directly to the front fender bolts. I have not noticed a significant amount of vibration but I also have not been paying that much attention to it. These lights for me are more about being seen instead of seeing. They do throw a lot of light down by the front tire. That is because they are mounted low. I put an Eastern Beaver fuse block and the lights and Skene controller are wired to that. The EB has 2 unswitched ports and the remaining lines are switched. These lights are on the switched ports. If you put the fuse block under the passenger seat there is a blue wire back there going to the tail light. That is the wire that is tapped for the EB. I also had to tap two wires up front. A high beam wire and the low beam wire. I can't recall what the colors are off hand. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
FJR Parts & Accessories Discussions
Auxiliary lights MondoMoto MM10
Top