Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Fork Guards; How Much Height Is Needed?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="TWILKIN650" data-source="post: 16079" data-attributes="member: 27"><p>I was thinking of using some of the remaining adhesive (Sikaflex-291 Technique Marine Sealant, made in France) left over from my install of the carbon fiber alternator guard. Cover the forks tubes behind the exisiting fork brace/protectors with plastic wrap to protect them, lay down a layer of adhesive on the back of the stock fork protectors and press them onto the front of the MCL protectors. Let cure and remove the plastic wrap. There shouldn't be much stress on the joint, so I wasn't planning on any additional screws to hold them in place. Does this sound adequate? Sure glad I kept the stockers!</p></blockquote><p></p>
[QUOTE="TWILKIN650, post: 16079, member: 27"] I was thinking of using some of the remaining adhesive (Sikaflex-291 Technique Marine Sealant, made in France) left over from my install of the carbon fiber alternator guard. Cover the forks tubes behind the exisiting fork brace/protectors with plastic wrap to protect them, lay down a layer of adhesive on the back of the stock fork protectors and press them onto the front of the MCL protectors. Let cure and remove the plastic wrap. There shouldn't be much stress on the joint, so I wasn't planning on any additional screws to hold them in place. Does this sound adequate? Sure glad I kept the stockers! [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Fork Guards; How Much Height Is Needed?
Top