Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
If you have bought, sold or gained information from our Classifieds, please donate to FJRForum and give back.
You can
become a Supporting Member
or just
click here to donate
.
FJR Classifieds
Group Buys
Helmet Lock Brackets
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bluzharp" data-source="post: 1342059" data-attributes="member: 90028"><p>I just finished installing my locks on both sides of my '16 ES. I got the locks from Yamaha Sports Plaza and was able to key them to my ignition key without any trouble. Had to swap two wafers on each lock and a bit of light filing to knock one high one down and voila!, Bob's your uncle. The biggest challenge is starting the nut on the back side of the right one. After dropping it over and over, I finally superglued it to the bracket which held it well enough to start the screw. I was then able to sneak a 10mm open end in there to tighten it up. A 6mm nutsert would be perfect here. Excellent product and looks good too! Thanks Scott!</p></blockquote><p></p>
[QUOTE="bluzharp, post: 1342059, member: 90028"] I just finished installing my locks on both sides of my '16 ES. I got the locks from Yamaha Sports Plaza and was able to key them to my ignition key without any trouble. Had to swap two wafers on each lock and a bit of light filing to knock one high one down and voila!, Bob's your uncle. The biggest challenge is starting the nut on the back side of the right one. After dropping it over and over, I finally superglued it to the bracket which held it well enough to start the screw. I was then able to sneak a 10mm open end in there to tighten it up. A 6mm nutsert would be perfect here. Excellent product and looks good too! Thanks Scott! [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Classifieds
Group Buys
Helmet Lock Brackets
Top