Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
SH__37 issue for the YCCS bikes
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="2GENAE" data-source="post: 1443738" data-attributes="member: 91909"><p>Brodie</p><p>Appreciate the info and for SURE I will use my front wheel chock, copy holding the bike upright. I drive up my ramp on my Direct Lift Pro Cycle DT with a pair optional 24" side rails and ramp extension into the chock and get off. After the rear is in the air a foot or two with the pipe stand I will strap the front to the lifts side rails, like on a trailer just for added safety. I will measure to see if the 5ft upright pipe is tall enough with FJR on lift. It's the Drop Tail version of the lift , the rear center of the rear of the lift floor slides out . It will give me more access under the frame and not be on my back. </p><p></p><p>This info for the chock helped a lot, as did you finding "The Smoking Gun "for error code 37, dust from the brushes on the armature... go figure. Huge Help to all AE owners, Just like your bypass ground harness for the 8 connectors with the " spider" distribution clips in them. Oh I packed my Brodie harness and all connectors for the ground harness with anti corrosion paste. My 2008 had the ignition switch and #4 ground wire recall done, checked it first week I owned it.. In the last three years I have learned a lot on this forum. Appreciate you sharing this with us. </p><p></p><p>Best Regards</p><p>Louis</p></blockquote><p></p>
[QUOTE="2GENAE, post: 1443738, member: 91909"] Brodie Appreciate the info and for SURE I will use my front wheel chock, copy holding the bike upright. I drive up my ramp on my Direct Lift Pro Cycle DT with a pair optional 24" side rails and ramp extension into the chock and get off. After the rear is in the air a foot or two with the pipe stand I will strap the front to the lifts side rails, like on a trailer just for added safety. I will measure to see if the 5ft upright pipe is tall enough with FJR on lift. It's the Drop Tail version of the lift , the rear center of the rear of the lift floor slides out . It will give me more access under the frame and not be on my back. This info for the chock helped a lot, as did you finding "The Smoking Gun "for error code 37, dust from the brushes on the armature... go figure. Huge Help to all AE owners, Just like your bypass ground harness for the 8 connectors with the " spider" distribution clips in them. Oh I packed my Brodie harness and all connectors for the ground harness with anti corrosion paste. My 2008 had the ignition switch and #4 ground wire recall done, checked it first week I owned it.. In the last three years I have learned a lot on this forum. Appreciate you sharing this with us. Best Regards Louis [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
SH__37 issue for the YCCS bikes
Top