Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Wicked Webby Air Box Mod Warning
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Karl" data-source="post: 617497" data-attributes="member: 14297"><p>This is nothing more than the old "Cdogs" mod seen here. <a href="https://www.fjrforum.com/forum/lofiversion/index.php/t105719-0.html" target="_blank">https://www.fjrforum.com/forum/lofiversion/.../t105719-0.html</a></p><p></p><p>All I did differently is use a holesaw to make nice clean cuts on the upper and lower radii. Then use a Dremel to trim the small V-shaped nubs that are left on the left and right sides of the oval where the holesaw didnt cut. Trim the snorkel tube on the left, clean up the cuts with sandpaper or file and you're done with the fabrication part.</p><p></p><p>I checked my TBS after and it was still good to go, but YMMV. Also, I have a PC3 and Richard did have to make a 3-4% adjust down low in the RPM range on the partial throttle columns as I was leaned out a bit below 4K. The 100% throttle was unchanged.</p></blockquote><p></p>
[QUOTE="Karl, post: 617497, member: 14297"] This is nothing more than the old "Cdogs" mod seen here. [URL="https://www.fjrforum.com/forum/lofiversion/index.php/t105719-0.html"]https://www.fjrforum.com/forum/lofiversion/.../t105719-0.html[/URL] All I did differently is use a holesaw to make nice clean cuts on the upper and lower radii. Then use a Dremel to trim the small V-shaped nubs that are left on the left and right sides of the oval where the holesaw didnt cut. Trim the snorkel tube on the left, clean up the cuts with sandpaper or file and you're done with the fabrication part. I checked my TBS after and it was still good to go, but YMMV. Also, I have a PC3 and Richard did have to make a 3-4% adjust down low in the RPM range on the partial throttle columns as I was leaned out a bit below 4K. The 100% throttle was unchanged. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Wicked Webby Air Box Mod Warning
Top