Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Off-Topic Discussion
Off-Topic Discussion
Wire Feed Welders
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="FJRay" data-source="post: 1385579" data-attributes="member: 312"><p>I use mine a lot and because it just uses shop air I'm not wasting expensive gas in the torch. I bought a good sized one because at the time I was doing a lot of aluminum stuff. It will do 3/8 aluminum and up to 3/4 in steel.. Don't do much aluminum tig work anymore cause my pacemaker isn't fond of the hifreq.</p></blockquote><p></p>
[QUOTE="FJRay, post: 1385579, member: 312"] I use mine a lot and because it just uses shop air I'm not wasting expensive gas in the torch. I bought a good sized one because at the time I was doing a lot of aluminum stuff. It will do 3/8 aluminum and up to 3/4 in steel.. Don't do much aluminum tig work anymore cause my pacemaker isn't fond of the hifreq. [/QUOTE]
Insert quotes…
Verification
Post reply
Off-Topic Discussion
Off-Topic Discussion
Wire Feed Welders
Top