Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Won’t start in neutral with side stand down 2008 Model
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="road runner" data-source="post: 1453744" data-attributes="member: 5116"><p>It sounds like dirty contacts inside the ignition switch. I had this happen. The bike will crank but not start. When this happens check for a fault code 19 to be displayed on gage. I think you will see it while cranking and no start. Once it starts code goes away. You should check the fault code history, write them down, then clear the history. If you cycle the key off, on a few times then it may start. The contacts inside the switch are dirty, and you can take the switch apart, clean, and put some di-electric grease in there then you'll be all set.</p><p></p><p>It was not the side stand going up and down it was the key being cycled.</p></blockquote><p></p>
[QUOTE="road runner, post: 1453744, member: 5116"] It sounds like dirty contacts inside the ignition switch. I had this happen. The bike will crank but not start. When this happens check for a fault code 19 to be displayed on gage. I think you will see it while cranking and no start. Once it starts code goes away. You should check the fault code history, write them down, then clear the history. If you cycle the key off, on a few times then it may start. The contacts inside the switch are dirty, and you can take the switch apart, clean, and put some di-electric grease in there then you'll be all set. It was not the side stand going up and down it was the key being cycled. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Won’t start in neutral with side stand down 2008 Model
Top