Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Won’t start in neutral with side stand down 2008 Model
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Sunnyorlando" data-source="post: 1455867" data-attributes="member: 92915"><p>I have the similar on my project bike.</p><p>It's an '03 - bike runs just fine, however.</p><p>Neutral light not working - </p><p>> checked bulb = good Sidetand down, clutch in - fuel pump primes, but no crank. Sidestand up, clutch in, fuel pump primes and engine starts. Bike in N (rear tire visually not spinning), move sidestand down, kills engine. This tests the sidetand switch as working in my mind. I also hear the starter cutoff relay clicking when pulling clutch and moving sidestand up & down. I believe this also confirms clutch and sidestand circuit talking to the cutoff relay.</p><p>I think I'm left with N switch - the circuit doesn't know it's in N.</p><p>I've been looking for the wires to the N switch so I can test to see if in fact it's working when switching between N and 1 or 2.</p><p>In the wiring diagram it shows a light blue to the starter relay from the N switch, and a lime green on the other side to the panel N indicator.</p><p>This is only place I can see it. If this is the case, is it as simple as testing this light blue to GND when pacing it in gear? Right now it's open - no GND.</p><p>I have not found a test procedure for this.</p></blockquote><p></p>
[QUOTE="Sunnyorlando, post: 1455867, member: 92915"] I have the similar on my project bike. It's an '03 - bike runs just fine, however. Neutral light not working - > checked bulb = good Sidetand down, clutch in - fuel pump primes, but no crank. Sidestand up, clutch in, fuel pump primes and engine starts. Bike in N (rear tire visually not spinning), move sidestand down, kills engine. This tests the sidetand switch as working in my mind. I also hear the starter cutoff relay clicking when pulling clutch and moving sidestand up & down. I believe this also confirms clutch and sidestand circuit talking to the cutoff relay. I think I'm left with N switch - the circuit doesn't know it's in N. I've been looking for the wires to the N switch so I can test to see if in fact it's working when switching between N and 1 or 2. In the wiring diagram it shows a light blue to the starter relay from the N switch, and a lime green on the other side to the panel N indicator. This is only place I can see it. If this is the case, is it as simple as testing this light blue to GND when pacing it in gear? Right now it's open - no GND. I have not found a test procedure for this. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Won’t start in neutral with side stand down 2008 Model
Top