Recent content by Stew00

🤣😂 I would probably go too far the other way... I am 99% sure it's the front fairing stay as well that's tweaked slightly. Before spending the money on one ($400 :eek:) I wanted to ask for a sanity check.

I have an 05 that I carefully measured against for frame side fairing mounts, so I know they are true and correct. I 100% agree that it will push the front headlight/fairing/dash to the left.

I picked up an '04 FJR for a great price that I knew had been previously laid down on the right side. When riding, I notice that where the ABS light is on the dashboard is off to the left by about 1/4 to 3/8 of an inch. I don't remember this being the case with my 05 FJR, and it's driving me...

Sent you a PM

Hello sir, Do you still have these? If measured in the center, can you tell me the height of each? I think I am wanting the taller touring screen. Thanks,

Are you still needing these? I probably have them on my 05 ABS that I laid down. Let me know

Hey Mark, Would you still have parts for this? I need the rear sub frame and the front fairing stay that holds the headlight\gauges etc (picture below).

Ok. I have done quite a bit of research. Looks like I can use the speed sensor that's on the Gen1 engine. The only think that the crankcase itself doesn't have a provision for is the gear position sensor. I am hoping that all I will need is the neutral sensing wire to be able to crank it...

Hello all, I wrecked my 2005 (Gen1) last May and have a chance to get a 2006 (Gen2) complete with a bad engine. So I will have both bikes as complete and I am wanting to transplant my low mile (18k) Gen1 into the Gen2 bike. I see a few posts of people going the other way but haven't found any...

PM sent for Gen 1 handlebar risers.

Pics? Are these OEM Yamaha?

Are these still available? What year did they come off of? And also do you have any more pics of the damage in detail.

Do you have the saddle bag liners? If so how much? I bought a bike used and it didn't have liners..

Is there any one around the Greensboro area of NC that has a Corbin Seat on there Gen1? I am thinking about picking one up here in the classifieds and would like to set on one first... I have no problems doing 3 hours on the stocker, so I am thinking that the Corbin should do me good for my...