Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Can anyone help no power on FJR NOT IGNITION SWITCH
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="RadioHowie" data-source="post: 575840" data-attributes="member: 426"><p>Here's the procedure to enter the "Diagnostics Mode":</p><p></p><p><strong>To enter Diagnostic Mode: Have the key turned off (kill switch on) and press the Select and Reset together. Turn the key to on and hold the buttons for about 8 seconds. A screen will apear that reads "d1 AG". release the buttons.</strong></p><p></p><p>Press Select and Reset again for 2 seconds. "d:01" should appear on the clock if you did everything right. You are now in the DIAG mode.</p><p></p><p>Press "SELECT" for the next code, Press "RESET" for the previous code.</p><p></p><p>Codes go from d:01 to d:70 -- go buy a manual for the codes.</p><p></p><p>Once you've entered the Diag Mode, press the "SELECT" button advance to #61. This will indicate how many codes have been stored in the ECU, and will also cycle through what codes have been stored. For example, when you first get to #61, it may display "1", then the "1" will change to "19". This would mean the ECU has stored ONE fault code, and that fault code, #19, is the sidestand switch.</p></blockquote><p></p>
[QUOTE="RadioHowie, post: 575840, member: 426"] Here's the procedure to enter the "Diagnostics Mode": [B]To enter Diagnostic Mode: Have the key turned off (kill switch on) and press the Select and Reset together. Turn the key to on and hold the buttons for about 8 seconds. A screen will apear that reads "d1 AG". release the buttons.[/B] Press Select and Reset again for 2 seconds. "d:01" should appear on the clock if you did everything right. You are now in the DIAG mode. Press "SELECT" for the next code, Press "RESET" for the previous code. Codes go from d:01 to d:70 -- go buy a manual for the codes. Once you've entered the Diag Mode, press the "SELECT" button advance to #61. This will indicate how many codes have been stored in the ECU, and will also cycle through what codes have been stored. For example, when you first get to #61, it may display "1", then the "1" will change to "19". This would mean the ECU has stored ONE fault code, and that fault code, #19, is the sidestand switch. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Can anyone help no power on FJR NOT IGNITION SWITCH
Top