st4gary
Well-known member
Wilber shock with all the trimmings:
- Remove pre-load adjustment
- Ride height adjustment
- Remote reservoir with high and low speed compression damping adjustment
- Rebound damping adjustable
This shock is off a Gen1. It was last serviced a year ago and has ~10k miles
on it since. Serviced at Ted Porter's Beemer Shop. I had it re-sprung again
during this past service and finally nailed what I wanted out of the shock.
The shock currently has a 0650 Eibach spring (#0600.225.0650). I had the
shock set up for 210lb solo ride. Also included is a heavier Eibach
spring (0600.225.0750) and also the original Wilbers spring (59/59-100-150).
So you can go either stiffer or softer by swapping out the spring.
Shock is boxed up in all the original packaging and comes with the original
installation documents, brackets and necessary hardware.
The remote pre-load bracket has been modified (extra hole drilled) so that
it can be mounted on a GenII or GenIII. I had the shock on my GenIII but had
a chance to move to Ohlins and went for it. Mostly because I wanted something
different and have Ohlins on a couple of my other bikes.
The price is $450 OTD, which includes shipping charges to CONUS and the
necessary PayPal charges.
Any questions PM or email to st4gary at hotmail.
Thanks,
Gary
- Remove pre-load adjustment
- Ride height adjustment
- Remote reservoir with high and low speed compression damping adjustment
- Rebound damping adjustable
This shock is off a Gen1. It was last serviced a year ago and has ~10k miles
on it since. Serviced at Ted Porter's Beemer Shop. I had it re-sprung again
during this past service and finally nailed what I wanted out of the shock.
The shock currently has a 0650 Eibach spring (#0600.225.0650). I had the
shock set up for 210lb solo ride. Also included is a heavier Eibach
spring (0600.225.0750) and also the original Wilbers spring (59/59-100-150).
So you can go either stiffer or softer by swapping out the spring.
Shock is boxed up in all the original packaging and comes with the original
installation documents, brackets and necessary hardware.
The remote pre-load bracket has been modified (extra hole drilled) so that
it can be mounted on a GenII or GenIII. I had the shock on my GenIII but had
a chance to move to Ohlins and went for it. Mostly because I wanted something
different and have Ohlins on a couple of my other bikes.
The price is $450 OTD, which includes shipping charges to CONUS and the
necessary PayPal charges.
Any questions PM or email to st4gary at hotmail.
Thanks,
Gary