Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Gen II Diagnostic Mode and d09 reading
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="rmcobb" data-source="post: 1434073" data-attributes="member: 16430"><p>In researching a fault code 14 issue, I was running thru the Diagnostics for the first time ever, which means I've never had a check engine light come on or any other reason to go in there.</p><p></p><p>So, when going thru all the different checks to verify the readings, I get to d:09 and it shows 0.0 ( manual says it should show a reading of 12.0). So mine showed 0.0</p><p></p><p>The Check Method then says to cycle the kill switch to the run position, and it will measure the actual battery voltage. I do that and the display changes to 11.1</p><p></p><p>This is strange as the battery is new, and my Datel voltmeter (connected directly to battery) indicates voltage at 12.4</p><p></p><p>Bike starts and runs fine (the fault code 14 appears to have corrected itself as I can't get it to repeat).</p><p></p><p>Anyone else have experience with d:09 readings?</p><p></p><p>Any other Gen II owner that wants to go out and play with this, I would love to know what you show.</p></blockquote><p></p>
[QUOTE="rmcobb, post: 1434073, member: 16430"] In researching a fault code 14 issue, I was running thru the Diagnostics for the first time ever, which means I've never had a check engine light come on or any other reason to go in there. So, when going thru all the different checks to verify the readings, I get to d:09 and it shows 0.0 ( manual says it should show a reading of 12.0). So mine showed 0.0 The Check Method then says to cycle the kill switch to the run position, and it will measure the actual battery voltage. I do that and the display changes to 11.1 This is strange as the battery is new, and my Datel voltmeter (connected directly to battery) indicates voltage at 12.4 Bike starts and runs fine (the fault code 14 appears to have corrected itself as I can't get it to repeat). Anyone else have experience with d:09 readings? Any other Gen II owner that wants to go out and play with this, I would love to know what you show. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Gen II Diagnostic Mode and d09 reading
Top