Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
If you have bought, sold or gained information from our Classifieds, please donate to FJRForum and give back.
You can
become a Supporting Member
or just
click here to donate
.
FJR Classifieds
Group Buys
Gen1 Subframe Stiffener Kit
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Bungie" data-source="post: 1073101" data-attributes="member: 11700"><p>Okay, time to eat some crow.</p><p></p><p>I went back and re-tried the installation again. Apparently, I was using the long bar in the vertical postion directly in front of the taillight sockets. Hence, no fit. I tried the same install again and couldn't even get the bar back there. WTF!</p><p></p><p>Did the install with the bar underneath the subframe closest to the fender liner, and the two studded pieces in front of the taillight sockets. I still ran into some interference with the mentioned mounts for my top case, but it was easy enough to rotate the plates and get them in place while still allowing all the bolt holes to line up.</p><p></p><p>I had ran wiring for my Admore kit and brake flasher through the access hole for the taillight sockets. It took longer to relocate those than it did to install the kit.</p><p></p><p>So, long story short, the kit installs as advertised so long as you actually read them <img src="data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7" class="smilie smilie--sprite smilie--sprite8" alt=":D" title="Big grin :D" loading="lazy" data-shortname=":D" /> </p><p></p><p>Nice job Gaurald!</p></blockquote><p></p>
[QUOTE="Bungie, post: 1073101, member: 11700"] Okay, time to eat some crow. I went back and re-tried the installation again. Apparently, I was using the long bar in the vertical postion directly in front of the taillight sockets. Hence, no fit. I tried the same install again and couldn't even get the bar back there. WTF! Did the install with the bar underneath the subframe closest to the fender liner, and the two studded pieces in front of the taillight sockets. I still ran into some interference with the mentioned mounts for my top case, but it was easy enough to rotate the plates and get them in place while still allowing all the bolt holes to line up. I had ran wiring for my Admore kit and brake flasher through the access hole for the taillight sockets. It took longer to relocate those than it did to install the kit. So, long story short, the kit installs as advertised so long as you actually read them :D Nice job Gaurald! [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Classifieds
Group Buys
Gen1 Subframe Stiffener Kit
Top