Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
Technical & Mechanical Problems
Hella FF50 with FuzeBlock Install Guide
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Fred W" data-source="post: 696587" data-attributes="member: 3828"><p>No problem.</p><p></p><p>Showing the schematics were probably overkill. I could have just said "Use the Blue/Green wire that goes to the heated grip controller", but I wanted to show you how you can figure this stuff out.</p><p></p><p>Also, as a side note: The handy heated grip wiring connector is NOT present on a 1st gen, so they'll have to use the wire that goes from headlight relay #1 to headlight relay #2 , which is not nearly so conveniently located, or the switched ground signal from the ECU itself (yellow wire). That's what I did for my <a href="https://www.fjrforum.com/forum//index.php?showtopic=113693&view=findpost&p=580261" target="_blank">HID headlight relay delay module</a>.</p><p></p><p></p><p>Which brings up a good point that I thought about when reading the OP: Why put the FuzeBlock in the rear of the bike when all the gizmos are up front? Seems like a lot of back and forth wiring to get it back there, unless you are mounting a lot of electronic stuff back there or under the seat. I bought one of these things this winter and have yet to figure out where exactly I want to mount it.</p></blockquote><p></p>
[QUOTE="Fred W, post: 696587, member: 3828"] No problem. Showing the schematics were probably overkill. I could have just said "Use the Blue/Green wire that goes to the heated grip controller", but I wanted to show you how you can figure this stuff out. Also, as a side note: The handy heated grip wiring connector is NOT present on a 1st gen, so they'll have to use the wire that goes from headlight relay #1 to headlight relay #2 , which is not nearly so conveniently located, or the switched ground signal from the ECU itself (yellow wire). That's what I did for my [URL="https://www.fjrforum.com/forum//index.php?showtopic=113693&view=findpost&p=580261"]HID headlight relay delay module[/URL]. Which brings up a good point that I thought about when reading the OP: Why put the FuzeBlock in the rear of the bike when all the gizmos are up front? Seems like a lot of back and forth wiring to get it back there, unless you are mounting a lot of electronic stuff back there or under the seat. I bought one of these things this winter and have yet to figure out where exactly I want to mount it. [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
Technical & Mechanical Problems
Hella FF50 with FuzeBlock Install Guide
Top