Forums
New posts
Search forums
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
FJR Motorcycle Forums
FJR Parts & Accessories Discussions
Stiffy kit - is the boss
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Yamaha FJR Motorcycle Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="graler" data-source="post: 1428067" data-attributes="member: 23510"><p>All is right with the world. One of the items damaged in my sons fall was the smuggler trunk. There is a steel plate that is riveted across the bottom - the ends of the plate catch the tabs under the passenger seat. This is what holds the back of the Smuggler down - the front is held by the rear seat latch.. I removed the rivets and bought some 3/16 stainless button head cap screws and nylok nuts and some washers. The .75 length was the perfect length to clamp everything back together. The smuggler is back on the bike. All of the plastics have been replaced and I am back in business. Funny thing - this mount feels much firmer than the riveted bar. I think when I rerouted some of the electrical I fixed another issue where the smuggler contact pads were sitting on wire and not the intended contact point.</p><p></p><p>Yolanda is ready to go now to pick some routes. </p><p></p><p>Joe</p></blockquote><p></p>
[QUOTE="graler, post: 1428067, member: 23510"] All is right with the world. One of the items damaged in my sons fall was the smuggler trunk. There is a steel plate that is riveted across the bottom - the ends of the plate catch the tabs under the passenger seat. This is what holds the back of the Smuggler down - the front is held by the rear seat latch.. I removed the rivets and bought some 3/16 stainless button head cap screws and nylok nuts and some washers. The .75 length was the perfect length to clamp everything back together. The smuggler is back on the bike. All of the plastics have been replaced and I am back in business. Funny thing - this mount feels much firmer than the riveted bar. I think when I rerouted some of the electrical I fixed another issue where the smuggler contact pads were sitting on wire and not the intended contact point. Yolanda is ready to go now to pick some routes. Joe [/QUOTE]
Insert quotes…
Verification
Post reply
FJR Motorcycle Forums
FJR Parts & Accessories Discussions
Stiffy kit - is the boss
Top