Recent content by Toynut

Well you might be on to something. Mine was definitely stuck in the on position when I checked. Thanks for the heads up.

I have that same odd clunking sound for a few seconds when my '08 is first started. I get an occasional hiccup during this period and an occasional stall if I try to blip the throttle (seems lean). Fast idle circuit does not seem to be up to speed either. This poor behavior is somewhat...

Good post. I have an MCCruise installed on my '08 (don't have it calibrated yet). I noticed that if I make a reasonably fast stop from around 50 mph or so, the ABS warning light begins to flash. I can shut the key and restart the bike and the flashing will then stop. Interesting to hear...

https://www.aerostich.com/catalog/US/Fluore...ion-sp-111.html

Yep, looks pretty much like the installation on my '08. The only difficult part was attaching the throttle cable to the throttle linkage. I made life much easier by removing the airbox and associated throttle body boots to gain easy access to the linkage. This only takes about 10 minutes with...

Received and installed my screws yesterday. Thank you Tim. :yes2:

Payment sent for two screws. Thank you for your efforts! :clapping:

I'm in for 2 pieces as well. Thanks!

You can also rotate the legs 90 degrees to flatten it out and lean it against the wall, should you be tight on space.

I have 2 Smarttire systems installed on some of my bikes. They do work well though I had to make some minor mods to the battery contacts in the display to get them to work consistently. The temps are in centigrade. They do come with nice billet aluminum 90 degree valve stems. The batteries...

I could use one for an '08 A model. Payment sent 7/1

At the risk of being assaulted on this thread............. :tomato2: after you use your Honda spray polish, invest a little time and money and apply this to your bike; https://www.webbikeworld.com/r2/glare-polish/glare-polish.htm

The only problem I can see with this approach is 1. There might be a clearance issues trying to put board and a floor jack under the plastics of a bike. :unsure: 2. The questionable stability of the lifted bike. I would be quite nervous working underneath a bike with this sole device...

L2M, check out this thread: https://www.fjrforum.com/forum//index.php?showtopic=106314

This is a very useful piece of equipment that is very easy to make. I added split foam pipe wrap to the uprights to protect the bike's finish. With the use of a ratchet strap and some soft ties, you can easily lift some of the heaviest bikes! https://www.fjr1300.info/howto/pipestand.html...