Long-Distance Endurance MT10 Project

Yamaha FJR Motorcycle Forum

Help Support Yamaha FJR Motorcycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Nice write up project. Question, only a 260 mile range? w the aux tank?

Correct. The MT-10 engine is notoriously thirsty right from the factory; after most owners have their ECU flashed for performance, mpg falls even further to 29-30mpg. So after flashing, low fuel light illuminates in 90-100 mile range. Obviously no good for Nevada purposes.

I bought the bike with the ECU already flashed, so I had it flashed back to factory specs. Between that, and dropping 2 teeth in the rear, I can get a consistent 34-35mpg, unless I go into Warchild-mode. A total of 8.8 gallons of fuel will have the low-fuel light illuminating somewhere at ~ 250-260 miles
 
Winter projects for the MT-10 includes a stunningly gorgeous carbon fiber headlight cowling. But you talk about a tedious install... oof! :confused:

First, removing all the factory front end:

1708614463469.png

This was not really a fun task...

1708614545415.png

There are quite a number of bit pieces/trim to move over from OEM cowling to the carbon fiber cowling. Key was obtaining a stubby 90-degree ratcheting Phillips-head driver (seen below, just above fastener bags) for dealing with those two lower mounting fasteners.

I bagged and tagged every set of fasteners removed in an attempt to avoid any leftover fasteners. :rolleyes: Hey... it's a goal!


1708614628992.png


Orange arrows below point to the upper two of four main retention screws that affix the headlight assembly to the nose of the bike. The upper bolts are cake to get to; the lower two are buried deep - the stubby 90-degree Phillips-driver saves a lot of cussing.

1708614854788.png


Left upper retention fastener. As mentioned, it's the lower two fasteners that are a butt-pain; they are a bit too close to the steering neck for regular stubby screwdrivers.

1708615030955.png


Oh, yes... Yes..... YEEEEEESSSSS!!!!!!!!! 🔥 🔥 🔥 🔥


1708615221087.png


More to come, I am not done here yet... :cool:
 
I had 2 first gen MT10’s and now have a second gen. Incredible bikes. I’ve done a few comfort/distance mods to mine but nothing near what you have done.
Awesome job!
 
This is turning out to be quite the winter make-over. Now I am in the Death Grip if installing Spiegler SS Brake lines. This is a slightly painful process due to all the ABS plumbing. Got some HEL interlopers on my Spiegler Stainless Steel line kit. Those four bleeders are for the ABS pump:

1710682775834.png


Stainless steel drama shot under the triple tree.
🔥


1710682853979.png


Most of the bike is black, so I just went with clear silver lines, silver fittings and stainless banjos to provide some contrast.

1710682935591.png


Lots of soft lines and hard lines. All of these lines are just for the front brake.

1710683036775.png
 
This is more intensive major surgery than I was hoping for. Not all that close to wrapping up this job; I have Samco hoses coming from England, so I have to leave the engine bay torn asunder until they arrive and are installed. Can't say I am looking forward to the bleeding job here...


1710768383298.jpeg
 
After 3 painful months - this Beast is finally back on the road. New powder-coating job on the Aux Cell that came out killer. The Spiegler SS Brake lines are incredible. The carbon fiber pieces were a huge ass-pain to install, but certainly look sweet. Ready for some 2024 adventures, finally! 🔥 🔥 🔥

Dayumation.jpg


1713552991104.png


1713553043774.png

30-degree Quad-LED Driving Lamps on top, 60-degree LED Driving Lamps below. All four Lamps together put out over 14000 lumens. This isn't counting the two lamps under the chin, or factory headlights.



1713553139512.png
 
After 3 painful months - this Beast is finally back on the road. New powder-coating job on the Aux Cell that came out killer. The Spiegler SS Brake lines are incredible. The carbon fiber pieces were a huge ass-pain to install, but certainly look sweet. Ready for some 2024 adventures, finally! 🔥 🔥 🔥

View attachment 6860


View attachment 6861


View attachment 6862

30-degree Quad-LED Driving Lamps on top, 60-degree LED Driving Lamps below. All four Lamps together put out over 14000 lumens. This isn't counting the two lamps under the chin, or factory headlights.



View attachment 6863
Looking great. What are the lights? Links?
 
Top