PLEASE HELP! 2011 wiring under seat

[TXFJR]

I'm trying to install skener photon blaster on my 2011. I searched and couldn't find a photo or thread that covered this. I am sure there is, but I am very frustrated with my bike taken apart!

I just need to confirm that the connector under the seat, that hooks up to the tail light wiring is as follows:

BLUE- tail light (switched 12v?)

YELLOW - brake light

GREEN - right turn signal

BROWN - left turn signal

BLACK - ground

Can anyone tell me if that's correct? for some reason I keep blowing the 10A hazard light fuse!

 

[mcatrophy]

Your colours are correct.

Hazard fuse is also used for the tail light (blue wire).

 

[TXFJR]

Thank you! I figured out what was happening. One of the Photon Blaster leads coming from the control module that I had not connected to the light itself was shorting itself out. Stupid mistake, but that's how we learn!