So, I'm trying to wire up my rostra cruise control unit and I'm hitting some minor road blocks. I'll try to list them below, and in addition, if a verification of my wiring "diagram" could be done, it would be highly appreciated. This on a 2006 FJR1300A
- So wiring to the 1st coil pack, everything says to wire to the orange wire on terminal 2. When I look at my ECU, however, there's an orange wire coming off terminal 1, with a grey with red stripe on terminal 2.
- Where does the yellow w/ green (First color listed is primary color, correct) run? I'm going to assume its in that loom that runs to the tail light?
- Do people typically hook up the red wire from the "module" unit that turns on/off the CC?
- Non rostra question. Is the license plate light housed within the same cable assembly that goes to the rear light?