Pjturbo
Well-known member
I installed it per the many directions on this forum, but I must be doing something wrong. I have an 05 with ABS. I connected the wires per instructions to the foot brake wires. On the first test run the unit would on engage. So I got out the VOM and started to check the wires. The purple wire has a constant .082 volts with the ignition on, goes to 11.8 volts with the brake engaged. The red wire has a constant 12.4 volts. The brown wire has constant .95 volts, when "on" is pushed this rises to 12.4 volts then goes back to .95 when "on" is released. When "off" is pushed it goes to 3.6 volts. When "set is pushed it ge 12.4 volts on the green wire. When "resume" is pushed I get 12.4 volts on the yellow wire. The blue wire has a constant 11.2 volts. For the LED, if I push and release the "on" button then push either "set" or "resume" the LED doesn't light. If I ush and hold the "on" button and push the "set" or "resume" the LED lights. With the engine running, if I push and hold the "on" button I get the blinking LED. I called audiovox and tried to some help. The person on the phone said they don't do motorcycles and to take the purple wire to ground. He didn't sound like he wanted to help. So I'm turning to people that do want to help. This Forum. Any suggestions will be gratfully accepted because I don't know what to try next and Audiovox doesn't want to tell me the logic diagram of the system.
Phil
Phil