Mogan
Well-known member
I'm in the final stages of wiring up my PHIDs and just about everything works great. I bought a "high amp" switch from electrical connection. It's a 7 blade double pole double throw illuminated switch that I'm using in a single pole configuration with a relay.
Blade #6 is connected to power via the bike's bus--this is used for simple on-off functionality
Blade #5 is connected to relay blade #1 (signal on voltage)
Blade #4 is connected to the yellow high beam wire--this turns the lights on when the brights are on.
It works great except I don't know how to wire the switch for illumination. I'm pretty sure blade #7 is for that purpose, but what should it be connected to???? I've tried ground and always on power. Neither work.
Ideas? :blink:
Blade #6 is connected to power via the bike's bus--this is used for simple on-off functionality
Blade #5 is connected to relay blade #1 (signal on voltage)
Blade #4 is connected to the yellow high beam wire--this turns the lights on when the brights are on.
It works great except I don't know how to wire the switch for illumination. I'm pretty sure blade #7 is for that purpose, but what should it be connected to???? I've tried ground and always on power. Neither work.
Ideas? :blink:
Last edited by a moderator: