Richouse
Well-known member
I have synced the Throttle Body's on my old FJR and have synced them once at the 600mi check on my new FJR. I have no question on how to do it, my question is how to set the #3 cylinder. All the directions have you syncing to the #3 but don't say (that I can find) how to set that one. I have the home made TBS sync tool listed HERE so I can't set it to a specific setting.
Reason I'm asking is after I bought it and rode it a while I noticed a 200 to 300 rpm pulse at idle, only when warmed up though. I didn't worry much since I would sync the TB at the 600mi. check. Well after I synced them it is still pulsing. Idle is set 1100rpm and it pulses up to about 1400rpm. I can just barley crack open the throttle (off idle) and make it stop.
I just figure that the #3 is not set right and when synced to it they are all not right.
Bike is a 2010 model with approx 1400 miles, The thought of the TPS is not right or bad has crossed my mind but being new I figure it just needs to be synced right?
So how do I set #3???
Thanks,
Reason I'm asking is after I bought it and rode it a while I noticed a 200 to 300 rpm pulse at idle, only when warmed up though. I didn't worry much since I would sync the TB at the 600mi. check. Well after I synced them it is still pulsing. Idle is set 1100rpm and it pulses up to about 1400rpm. I can just barley crack open the throttle (off idle) and make it stop.
I just figure that the #3 is not set right and when synced to it they are all not right.
Bike is a 2010 model with approx 1400 miles, The thought of the TPS is not right or bad has crossed my mind but being new I figure it just needs to be synced right?
So how do I set #3???
Thanks,