Search results

Thanks rushes and fjrrider. My bad - it WAS 1.0 thread as you say Problem solved Paul

Hi Guys I have a 2001 uk fjr and my front disc bolts need replacing due to the effects of the weather. I have the new M6 bolts (also fit the R1/R6 bikes) and need a tap to clean out the old threads of muck and locktite. The thing is the threads are 1.25 mm and I can't find a suitable tap in...

Thanks for your thoughts, guys!

Hi guys During an inspection earlier this year, I found the front pistons were badly corroded. I now have new pistons and have the following questions: 1. If I do not undo the master cylinder lid when I remove the brake line and pistons from the caliper will the vacuum hold the fluid in...

The wise advice over here is to check the pressures each time you ride :rolleyes:

Peter This is what I used: Bike Johnny

Since writing last year about my clutch problem, I bled the clutch line with no improvement and concluded, as a layperson, that the problem was throttle/fuel injection.

Here in uk it's every 2 years

Thanks for clarifying, ohio

I thought the pistons were chrome and a polishing wheel would damage it. No? Thanks for your ideas Don't we have to be careful using water anywhere near brake fluid as it is hygroscopic? Thanks again

Bump! Pierre and I can't be the only ones to have tackled this chore <_<

String, now that's a novel idea - would never have thought of that for cleaning. Thanks Pierre Anyone figured out how to rotate the pistons in situ? As the seals are so prohibitively expensive, has anyone removed the existing ones, cleaned out the grooves and, coated the seals in red rubber...

Dear all A year ago I removed my front calipers (for the first time in 4 years - and regretted leaving it so long) and was shocked at the crud on the pistons. I cleaned as best I could with a toothbrush and brake cleaner but realised that there is a small area on each piston where the...

See Ebay

Thanks for your thoughts guys The situation is that my bike has been really looked after, not thrashed I use Motul 5100 4T Ester Blend 10W-40 which is a synthetic SPI SG spec and within the range approved by Yam uk. Oil and filter changed every 3k miles Radman Not sure why you said "Not the...

Hi everyone I've been riding my 01 fjr for nearly 3 years now and I've just noticed that the clutch does not bite hard when taking off in first gear compared to a car say - it is more of a smooth action The point is that I had to start off at the bottom of an extremely steep hill recently and...

What do you mean by a 'failsafe circuit' and why should it affect splicing into the tail light wires?

Yep, I have 14.1 even with all lights on Lookn Good :)

Hi ignacio As I'm in the uk I got the switch/cover from Maplin (similar to radio shack) - not many of the forum members likely to be interested therefore. The only differences in my final set compared to Warchild's suggestions are: 1.ran + and -ve leads from Blue Seas and inserted a 3amp fuse...

As I've said before, you guys give me the confidence I never knew I had. Many thanks Here's the finished job: Datel with On/Off Switch