VFR Rider
Well-known member
So, I hit the 600 mile mark within a week of buying the bike and thought I would take the opportunity to farkle the bike while I had it apart. So finally, I have it all back together. Here's what's new on the bike...
1) 12V Barrier Strip installed in Front under panel Panel D
2) Added PIAA 1100X driving lights mounted on the fender
3) Added Scorpio alarm w/ perimeter sensor
4) Added "always hot" powerlet in Panel A
5) Added Datel volt meter in Panel A
6) Added MANIC Salamander Bar End weights
7) Added a Givi V46 trunk with brake light kit
8) Added Motovation no-cut frame sliders
9) Added Ram Mounts for my eTrex Color GPS
10) Added Backoff module hooked to Givi brake lights and LED bar mounted under Givi rack
11) Added rear double powerlet mounted on rear passenger peg
12) Added Blue Sea power distribution block in rear tail
And last but not least will be a set of Leo Vince titanium slip ons which should arrive this week. Here are some photos of the bike as it is now. Time to get out and ride...
1) 12V Barrier Strip installed in Front under panel Panel D
2) Added PIAA 1100X driving lights mounted on the fender
3) Added Scorpio alarm w/ perimeter sensor
4) Added "always hot" powerlet in Panel A
5) Added Datel volt meter in Panel A
6) Added MANIC Salamander Bar End weights
7) Added a Givi V46 trunk with brake light kit
8) Added Motovation no-cut frame sliders
9) Added Ram Mounts for my eTrex Color GPS
10) Added Backoff module hooked to Givi brake lights and LED bar mounted under Givi rack
11) Added rear double powerlet mounted on rear passenger peg
12) Added Blue Sea power distribution block in rear tail
And last but not least will be a set of Leo Vince titanium slip ons which should arrive this week. Here are some photos of the bike as it is now. Time to get out and ride...
Last edited by a moderator: